 |
 |
|
 |
 |
113
--map=<file>
This option explicitly specifies the name for the map file. In the absence of this option, the map file name
is derived from either the project file, if specified, or the first file compiled. If an earlier or later option
specifies no map file should be generated this option is ignored. Currently, no map file is generated for
native mode devices.
--no-code
This option causes the compiler to omit the code generation step. By implication, no map file will be
generated either. This may be useful if all you want is a syntax check.
--no-map
This option causes the compiler to omit map file generation.
--optimize=<optimization-type>[,<optimization-type>...]
This option enables or disables specific types of optimizations. In most cases, you’ll want to use the
default optimization settings. This option is provides for unusual circumstances where more control is
needed over the optimizations performed. The optimization types are described in the table below. To
disable an optimization type, add the prefix no- to the optimization type, e.g. no-strength-
reduction. All optimization can be turned off using –-optimize=no-optimize.
|
 |
|