Forum Index
HomeZBasic Home   Forum RulesForum Rules   Forum FAQForum FAQ   MemberlistMemberlist   UsergroupsUsergroups   RSS FeedRSS Feed
Site SearchSite Search   LinksLinks   DownloadDownload   Digests and SubscriptionsDigests and Subscriptions
ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in   RegisterRegister
Multi-Z "Cell I/O" interfacing

 
Post new topic   Reply to topic    Forum Index -> Files
Author Message
zbasicandy



Joined: 26 Jan 2006
Posts: 193
Posted: 12 July 2006, 13:26 PM    Post subject: Multi-Z "Cell I/O" interfacing Reply with quote
The other day, in the lab, we found interfacing to a Multi-Z buss card to
a "solid state relay Cell I/O" might be hazardous to your health. The rating is 240 VAC but the "track to track" spacing going to the terminal block connector is only 0.10 inch spacing. This printed circuit board layout mistake could cause arc-over and shorts if you use this module at 240 VAC. Be forewarned.

Smile Smile Smile
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Forum Index -> Files Time synchro. with the server - Timezone/DST with your computer
Page 1 of 1

 


All content Copyright © 2005-2012 Elba Corp. All Rights Reserved.
Opinions expressed in posts are those of the author and not necessarily those of Elba Corp.
Powered by phpBB © 2001, 2005 phpBB Group