Forum Index
HomeZBasic Home   Forum RulesForum Rules   Forum FAQForum FAQ   MemberlistMemberlist   UsergroupsUsergroups   RSS FeedRSS Feed
Site SearchSite Search   LinksLinks   DownloadDownload   Digests and SubscriptionsDigests and Subscriptions
ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in   RegisterRegister
ZB Language Ref manual -- errata on ZX-44 pins

 
Post new topic   Reply to topic    Forum Index -> ZBasic Language
Author Message
jay



Joined: 08 Jul 2006
Posts: 22
Location: Vermont, USA
Posted: 01 August 2006, 18:02 PM    Post subject: ZB Language Ref manual -- errata on ZX-44 pins Reply with quote
I'm beginning to lay out a design using the ZX-44. As I go over the pins in the ZB Ref Manual vs the Atmel spec, I found (D.2 ZX-44) the note below "ZX-44 Power Source" should change as follows" "In this case, pin 30 would be.." should read ".., pin 27 (AVCC) would be.." then ".. Pin 32 can be left open.. " should read "..pin 29 (AREF) can be " and "ground pins 11 and 31" should read "ground pins 39, 28, 18 and 6". Maybe add a pin 6 on drawing.
.. Jay
Back to top
dkinzer
Site Admin


Joined: 03 Sep 2005
Posts: 2593
Location: Portland, OR
Posted: 01 August 2006, 23:08 PM    Post subject: Reply with quote
Thanks for pointing out this error. It has been fixed in the internal working draft.
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Forum Index -> ZBasic Language Time synchro. with the server - Timezone/DST with your computer
Page 1 of 1

 


All content Copyright © 2005-2012 Elba Corp. All Rights Reserved.
Opinions expressed in posts are those of the author and not necessarily those of Elba Corp.
Powered by phpBB © 2001, 2005 phpBB Group